Partic. vol. 29 pp. 143-153 (December 2016)
doi: 10.1016/j.partic.2016.03.003

Experimental investigation into transient pressure pulses during pneumatic conveying of fine powders using Shannon entropy

Amit Goel^*, Anu Mittal, S.S. Mallick, Atul Sharma

amitgoel3304@gmail.com

Abstract

This paper presents the results of an ongoing investigation into transient pressure pulses using Shannon entropy. Pressure fluctuations (produced by gas–solid two-phase flow during fluidized dense-phase conveying) are recorded by pressure transducers installed at strategic locations along a pipeline. This work validates previous work on identifying the flow mode from pressure signals (Mittal, Mallick, & Wypych, 2014). Two different powders, namely fly ash (median particle diameter 45 μm, particle density 1950 kg/m³, loosely poured bulk density 950 kg/m³) and cement (median particle diameter 15 μm, particle density 3060 kg/m³, loosely poured bulk density 1070 kg/m³), are conveyed through different pipelines (51 mm I.D. × 70 m length and 63 mm I.D. × 24 m length). The transient nature of pressure fluctuations (instead of steady-state behavior) is considered in investigating flow characteristics. Shannon entropy is found to increase along straight pipe sections for both solids and both pipelines. However, Shannon entropy decreases after a bend. A comparison of Shannon entropy among different ranges of superficial air velocity reveals that high Shannon entropy corresponds to very low velocities (i.e. 3–5 m/s) and very high velocities (i.e. 11–14 m/s) while low Shannon entropy corresponds to mid-range velocities (i.e. 6–8 m/s).

Graphical abstract

Keywords

Transient pressure fluctuations; Fluidized dense phase; Shannon entropy; Flow pattern; Solid loading ratio; Superficial air velocity